Q: How to connectors/jumpers for SCSI ID

Thread View: comp.sys.mac.hardware.storage

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by Keehwan Hong Thu, 04 Jan 1996 15:17

#86

Author: Keehwan Hong
Date: Thu, 04 Jan 1996 15:17

39 lines
1367 bytes

  I have a SCSI harddisk (IBM deskstar) and an external box.
  I want to connect connectors (from thumb-wheel switch for SCSI ID
  in the external box) to jumpers (in the hard drive), and
  want to connect for LED.

  
* Connectors from the box represents as follows:

  Color  Black  Yellow  Blue  Red
  ID SW   COM     4      2     1

  Color  Red    Black
  LED     +       -


* Pins in the hard disk represents as follows:

  SCSI ID    Position
             1   2   3
     6       :  []  []
     5      []   :  []
     4       :   :  []
     3      []  []   :
     2       :  []   :
     1      []   :   :
     0       :   :   :

  LED        Position
             7
             :

* Question:
  0.  What kind of parts are needed to connect these?
  1.  Where can I buy the parts?
  2.  Would you explain how to connect?

  Thanks in advance.

  from Keehwan Hong (khong@magnus.acs.ohio-state.edu)

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads