🚀 go-pugleaf

In article <2649@husc6.UUCP> olson@endor.UUCP (Eric Olson) writes:

>I don't remember any Save Configuration.. item in any MacTerminal I've ever
>used!  However, I, too, like to have my settings in MacTerm and not in
>some document.  You can do it like so:
>
>	- Run MacTerminal
>	- Set it up like you want it
>	- Save the document somewhere
>	- Quit, run ResEdit
>	- Copy CNFG 0 from the document to MacTerm.

Before I obtained MacTerminal 2.2, I was using a version 2.0 that was site
licensed to Cornell.  There were a couple of small modifications made to the
program by our Computer Services Department, but I didn't think that the
"Save Configuration" menu item was one of the mods.  Perhaps it was.  "Save
Configuration" was right under "Save As.." on the file menu.

Thanks for the tip on copying over the CNFG resource from the document to the
application - I should have thought of that.  It did the job. 
-- 
Julian Vrieslander    (607) 255-3594
Neurobiology & Behavior, W250 Mudd Hall, Cornell University, Ithaca NY 14853    
UUCP: {cmcl2,decvax,rochester,uw-beaver,ihnp4}!cornell!batcomputer!eacj
ARPA: eacj@tcgould.tn.cornell.edu     BITNET: eacj@CRNLTHRY