Article View: comp.sys.mac
Article #2452Re: Problems configuring CDC Wrens to Macs
From: Marc T. Kaufman
Date: Sat, 05 Aug 1989 01:37
Date: Sat, 05 Aug 1989 01:37
19 lines
1403 bytes
1403 bytes
In article <16553@ut-emx.UUCP> xdaa374@ut-emx.UUCP (William T. Douglass) writes: >Configuration: > 40 MB Quantum internal HD > CDC Wren 94161-155 (w/ SCSI controller, 155 MB capacity) Internal drive is SCSI ID 0, system is ID 7. Drive has been configured as ID 1, 2, 3, and 4. Terminators have been place integral to the drive, as well as on the SCSI cable itself. Terminator power has been specified as coming from the drive itself (not from the Mac.) You have too many terminators. There is one on the Internal drive, one set in the Wren, and one one the cable. Take off the cable terminator. NB: Wren terminators are 3 SIP resistor packs on the edge of the circuit board nearest the SCSI connector. They are socketed. Remember the orientation if you remove them. Marc Kaufman (kaufman@polya.stanford.edu)
Technical Details
Message-ID:
<11131@polya.Stanford.EDU>Path:
arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!ucbvax!decwrl!shelby!polya!kaufmanReferences:
<16553@ut-emx.UUCP>Show Full Headers
Complete Article Headers
Path: arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!ucbvax!decwrl!shelby!polya!kaufman From: kaufman@polya.Stanford.EDU (Marc T. Kaufman) Newsgroups: comp.sys.mac Subject: Re: Problems configuring CDC Wrens to Macs Keywords: CDC Wrens, configuration, SCSI conflicts Message-ID: <11131@polya.Stanford.EDU> Date: 5 Aug 89 01:37:22 GMT References: <16553@ut-emx.UUCP> Sender: Marc T. Kaufman <kaufman@Polya.Stanford.EDU> Reply-To: kaufman@Polya.Stanford.EDU (Marc T. Kaufman) Organization: Stanford University Lines: 19