🚀 go-pugleaf

I have been struggling with what I think is generic SF&I (Ephriam Vishniac's)
to try and format my Priam drive attached to an Adaptec 4000A or 4070
SCSI-to-ST506 controller.  I'm sure I'm doing something wrong.  I read a
while back that there was a version of SF&I tailored for the Adaptec family,
and I hope some kind reader can e-mail it to me or point me to a source.
(NOTE: The version on SUMEX is the same as the one I already have.)

Barring that, perhaps someone can elucidate the changes one needs to make
to the SF&I resources using ResEdit that is clearer than the doc I have.
I *think* the only changes necessary (to the "Vanilla Resources") are to
specify the drive size (in sectors) and partition size (=drive size - 8?).
Beyond that, I'm stumped.  In the IBM disk world, one would need to tell
the formatter about # of heads and cylinders--I don't know if this is
calculated by SF&I somehow from the drive size.  Frankly, I don't see how
it could.

Sigh.....I hope someone can help!  :(

Thanks in advance.

marc

=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
= Marc Johnson			    BITNET:   rna!marc@rockvax.bitnet         =
= Rockefeller Univ. Neurobiology    UUCP:     ...cmcl2!rna!marc               =
= New York City                     INTERNET: marc%rna@rocky2.rockefeller.edu =
=                                             (129.85.2.1)                    =
=                                                                             =
= "Gimme the beat boys and free my soul, I wanna get lost in your rock & roll =
=                           ...and drift away"                                =
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=