🚀 go-pugleaf

In article <1992Oct21.172218.7845@leland.Stanford.EDU> jay@cmn19.Stanford.EDU  
(Jay Kadis) writes:
> 
> Does anyone know how to get a NeXTDimension board to run under 3.0?  We  

Should just work. Did so on our ND system.

> could find no reference to NeXTDimension in the 3.0 upgrade docs, but  
> there's a specific warning in the install disk that says to only use 2.1.   
> To make matters worse, the color monitor crashed and NeXT wants to sell us  
> a reconditioned one for $100 less than a new one...some help.  We want to  
> use the RGB or S-video outputs to our Sharp LCD projector and so far it's  
> no go. Any help would be appreciated!

The connectors on the NeXTdimension board usually don't carry any signals
if not told to do so. Especially they don't (and can't) output the
whole screen image. Start up e.g. ScreenScape from /NextDeveloper/Demos
to have a part of the ND screen contents output to these connectors.
By default the visible rectangle of the screen should follow the cursor.

--
Detlev Droege                          | droege@infko.uni-koblenz.de
Universitaet Koblenz,                  |       (NeXTmail ok)
Institut fuer Informatik               | Voice: +49 261 9119-421
Rheinau 3-4, D-5400 Koblenz, Germany   | Fax:   +49 261 9119-499