Configuration for a SupraFaxModem v.32bis

Thread View: comp.sys.next.sysadmin

2 messages

[T] Back to Threads [V] Tree View [G] Group Articles

2 total messages Started by Reuven M. Lerner Sun, 11 Oct 1992 05:21

#1422

Author: Reuven M. Lerner
Date: Sun, 11 Oct 1992 05:21

11 lines
1013 bytes

Has anyone managed to install a SupraFaxModem v.32bis under 3.0? If
so, would you mind sharing your configuration files with me?

I've managed to get my modem working, but not at speeds above 9600.
Perhaps I'm just new at dealing with /etc/ttys and /etc/remote, and
perhaps the cable isn't really doing the hardware handshaking that
it's supposed to be doing. In any event, I'm a bit confused, and would
like to take a look at someone else's setup.

Reuven
(No NeXTmail)

Re: Configuration for a SupraFaxModem v.32bis

#1439

Author: Waihon Andrew Kwong
Date: Mon, 12 Oct 1992 03:23

37 lines
1882 bytes

In article <REUVEN.92Oct11012051@marinara.mit.edu> reuven@athena.mit.edu (Reuven M. Lerner) writes:
>Has anyone managed to install a SupraFaxModem v.32bis under 3.0? If
>so, would you mind sharing your configuration files with me?
>
>I've managed to get my modem working, but not at speeds above 9600.
>Perhaps I'm just new at dealing with /etc/ttys and /etc/remote, and
>perhaps the cable isn't really doing the hardware handshaking that
>it's supposed to be doing. In any event, I'm a bit confused, and would
>like to take a look at someone else's setup.
>
>Reuven
>(No NeXTmail)

I'm using a ZyXEL fax modem and I have the same problem at first, too.

Then, I changed the entries in /etc/ttys and /etc/remote, especially
in /etc/remote, there is several statement that has UNIX-1200......

Change it to 9600 will solve the problem.

Change it to the followings**************/etc/remote
UNIX-9600|9600 Baud dial-out to another UNIX system:\
	:el=^U^C^R^O^D^S^Q@:ie=#%$:oe=^D:tc=dial9600:
UNIX-300|300 Baud dial-out to another UNIX system:\
	:el=^U^C^R^O^D^S^Q@:ie=#%$:oe=^D:tc=dial300:
#
tip0|tip9600:tc=UNIX-9600:
tip300:tc=UNIX-300:
cu0|cu300:tc=UNIX-300:
cu9600:tc=UNIX-9600:
dialer:dv=/dev/cua:br#9600:
******************************************

I'm not sure if there is any side effect, but it works fine for me!

Later,
Andy

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads