🚀 go-pugleaf

I've been trying to get our indial lines to work on a round robin set of
baud rates, (9600, 1200, 2400, 19200) and haven't been having any luck.
I've been using the gettytab entries below, with the /etc/ttys entries
set to begin with 1V.  It appears I can get most any individual speed to
work just fine, but I can't seem to get the init/getty to notice a break
and move to the next table.  These entries work exactly right on a Sun,
and I don't see anything that's against TFM.  Anyone out there done this,
and if so, is there something I'm missing?  Any help would be appreciated.

Gettytab entries are:
T|C1200:\
        :nx=C2400:fd#1:sp#1200:ht:
U|C2400:\
        :nx=C19200:sp#2400:ht:
V|C9600:\
        :nx=C1200:sp#9600:ht:
W|C19200:\
        :nx=C9600:sp#19200:ht:

-- 
-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-
| There is nothing in the above message that can't be explained by sunspots.  |
|                   execu!dewey             Dewey Henize                      |
|         Can you say standard disclaimer?  I knew you could.  Somehow...     |