Article View: comp.sys.sequent
Article #750Re: gettytab
From: Ronald O. Christian
Date: Thu, 02 Feb 1989 18:27
Date: Thu, 02 Feb 1989 18:27
19 lines
1235 bytes
1235 bytes
In article <423@execu.UUCP> dewey@execu.UUCP (Dewey Henize) writes:
>I've been trying to get our indial lines to work on a round robin set of
>baud rates, (9600, 1200, 2400, 19200) and haven't been having any luck.
Same here. Never did get it to work. It's been awhile, but I seem
to remember that successive BREAK commands would cycle up through
the baud rates, but as soon as it got to 9600 (or was it 19200?)
it would stick. Personally, I think it's a problem with the Systeks.
If you're trying to interface your tty lines to Telebits, try locking
the interface speed at 9600 (if data integrity is a must) or 19200
(if you don't mind a few dropped characters).
Ron
--
Ronald O. Christian (Fujitsu America Inc., San Jose, Calif.)
{amdahl, pyramid, sun, unisoft, uunet}!fai!ronc -or- ronc@fai.com
Technical Details
Message-ID:
<1730@fai.UUCP>Path:
arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!bloom-beacon!apple!amdahl!fai!roncReferences:
<423@execu.UUCP>Show Full Headers
Complete Article Headers
Path: arc1-ca.pugleaf.net!utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!bloom-beacon!apple!amdahl!fai!ronc From: ronc@fai.UUCP (Ronald O. Christian) Newsgroups: comp.sys.sequent Subject: Re: gettytab Message-ID: <1730@fai.UUCP> Date: 2 Feb 89 18:27:11 GMT References: <423@execu.UUCP> Reply-To: ronc@fai.fai.com (Ronald O. Christian) Organization: Fujitsu America, Inc. Lines: 19