🚀 go-pugleaf

In article <423@execu.UUCP> dewey@execu.UUCP (Dewey Henize) [ME] writes:
>I've been trying to get our indial lines to work on a round robin set of
>baud rates, (9600, 1200, 2400, 19200) and haven't been having any luck.
>I've been using the gettytab entries below, with the /etc/ttys entries
>set to begin with 1V.  It appears I can get most any individual speed to
>work just fine, but I can't seem to get the init/getty to notice a break
>and move to the next table.  These entries work exactly right on a Sun,
>and I don't see anything that's against TFM.  Anyone out there done this,
[details of what I tried omitted]

Since posting, I've recieved a note from a person at Sequent and have talked
to them on the phone.  It appears this is a known bug, but get this -
THERE'S A KNOWN FIX!  I know, I know, no big deal to many of you, but with
the frustrations those of us in multi-vendor sites often experience, its
really nice to come across this occasionally.  Anyhow, there's a fix tape
on the way.

As an nice side note, while discussing the problem with the person from 
Sequent, we were able to also bring up and handle a few other issues that
I wasn't real sure about in their implementation.  In the whole discussion,
I never got the feeling that the person was trying to just shunt me off and
move on, but instead felt that the issue to me and to them was to get the
problems resolved.  Nice to run into.

Dewey Henize
Execucom Systems Corp

-- 
-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-
| There is nothing in the above message that can't be explained by sunspots.  |
|                   execu!dewey             Dewey Henize                      |
|         Can you say standard disclaimer?  I knew you could.  Somehow...     |