ROI Question cont'd.

Thread View: comp.sys.sgi.graphics

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by SHALEE Tue, 26 Jan 1993 20:01

#144

Author: SHALEE
Date: Tue, 26 Jan 1993 20:01

14 lines
1109 bytes

An ROI'd image with parameters set to display within the ROI only seem to
work if the top of the ROI is = 384.  Starting with a 2 size ROI in the lower
left hand corner, the bottom 1/4 of the image is correct, with the top 3/4
unchanged, except for horizontal lines at the 1/2 and 3/4 mark.  If the size
of the ROI increases to 1/4 of the image height, then the bottom half displays
correctly.  When it touches the 1/2 image height mark, 3/4 of the image
displays correctly.  I have tried mucking with PageSize to no avail.
The image is a 512x512 TIFF file.  Page size defaults to 65536 pixels.
Has anyone else noticed this behavior?
Any ideas on parameters to change, etc. would be appreciated.

Stephen Shaler
University of Maine
steve@pith.umecfr.maine.edu

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads