Error pin

Thread View: comp.sys.transputer

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by EDMONDS Mon, 25 Jul 1988 14:05

#2150

Author: EDMONDS
Date: Mon, 25 Jul 1988 14:05

20 lines
1097 bytes

In response to the question:

>Our impression is that the error pin on a transputer stays set even after
>the processor has been reset, and does not clear until code is loaded -
>is this really the way it works??

The error pin is directly connected to the processor's error flag. If it
is high then an error, e.g. arithmetic overflow, divide by zero, array bounds 
violation or software setting of the flag has been detected. Once set, the 
flag can only be cleared by the "testerr" instruction and IS NOT cleared by 
a reset. This is so analysis can detect which processor caused the error.

Hope this clears up a few points.


Mark Edmonds
UK.AC.RHBNC.PHV1

P.S.   Does anyone know when the T801 (optimised for static RAMS) will 
       materialise?

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads