🚀 go-pugleaf

FWIW at this point in time, I did record from LP a short while ago. There
was nothing out of the ordinary which needed to be done.  Make sure cables
are ok and that any plugs used are stereo. Whatever you set as the recording
source (Line -Mic) in Mixer should also be enabled  (not muted) as an output
source.  "What you hear" is a bad choice of recording input... it disables
most of the output sliders and will record system sounds (wavs etc.) along
with your LP.

Cheers,



"Noel" <noel@noelverhoeven.com> wrote in message
news:93jakv$i8f$1@news.creativelabs.com...
> Hi,
>
> I want to record my LP's also. However, I cannot get any sound to be
> recorded. I have a stereo Y plug from my Tape/Rec out on the receiver into
> the line in jack on the Live 5.1.
>
> I've tried also the microphone, but again, no monitor sound.
>
> Anyone?
>
>
> Marcel Benoit <embenoit@attcanada.ca> wrote in message
> news:92d9mk$d0s$1@news.creativelabs.com...
> > I am having trouble recording my LP's. I connected through the line in
> jack
> > using a Y connector from my mixer. I only get mono recorded even though
> the
> > recorder says Stereo. How can I fix this?
> >
> > Marcel
> >
> >
>
>