🚀 go-pugleaf

Hello again managers,

Thanks to 
 o Dr. Alan Rollow (again!)
 o Oisin McGuiness 
 o Stephen Adler

The solution that best fit my situation was provided by Oisin McGuiness. 
He specifed the correct line to add to the config file was: 

	device  fb0     at      ibus?   vector  fbint

And it worked :-) (note that booting the generic kernel image was not
possible).

		Rich

My original post:
On Sat, 31 Oct 1998 richmc@entropy.ucsc.edu wrote:
> Hello Managers,
> 
> I am attempting to rebuild the kernel for a DECStation 500/240
> running Ultrix 4.4 (upgraded from 4.2) after swapping video cards
> (PMAG-D to PMAGB-B).  I editted the configuration file to reflect
> the change based upon old documentation.
> During 'make' I am seeing an error related to an option in the configuration
> file (surprise, surprise).  The message is:
> cc -EL -I. -c -G 8 -O2 -g3 -I. -I.. -DTHOTH -DDS5000_300 -DUWS -DDECNET -DSYS_TPATH -DAUDIT -DPACKETFILTER -DCDFS -DLAT -DNETMAN -DUFS -DDLI -DRPC -DNFS -DINET -DQUOTA -DMIPS -DKERNEL  -c vers.c
> loading vmunix
> /bin/ld:
> Undefined:
> pmdriver
> pmvint
> lk201_keyboard_event
> lk201_getc
> lk201_modifiers
> lk201_keysyms
> lk201_keycodes
> lk201_definition
> lk201_putc
> lk201_init_closure
> lk201_up_down_mode
> lk201_reset_keyboard
> lk201_set_keyboard_control
> lk201_ring_bell
> *** Error code 1
> 
> Stop
> (end of message)
> 
> The old line pertaining to the video card is:
> device          px0          at ibus?     vector pxintr
> The new line is:
> device          pm0          at ibus?     vector pmvint
> Can someone tell me the correct option for the configuration file?
> 
> 		thanks,
> 		Rich
>