🚀 go-pugleaf

Hello ! I am new here and would like some help ... I am trying to compile 
gcc-2.7.1 on a Sun sparc station running V.3 to be used on a Sparc 10 V.4
These are the following steps that I use to do so ... 

   I. make distclean # just to clean out anything from before 
    
   II. configure --build=sparc-sun-solaris --perfix=/mnt/opt/gcc-2.7.1/local
    
   III.	make LANGUAGE=c

   IV. make stage1


For stage I, I clean up old files ... start fresh. 

For stage II, I set the path so that /usr/bin precedes
/usr/ucb. 		

For stage III, after this runs ( and during, I receive warnings not listed
in the INSTALL manual ) I get the following errors:

   * various warnins regarding the semantics of '<=' and '=>' have changed
   
For stage IV, get the following errors:

[snipped]
mv: cannot access collect2
mv: cannot access *.greg
mv: cannot access *.lreg
mv: cannot access *.combine
mv: cannot access *.flow
mv: cannot access *.cse
mv: cannot access *.jump
mv: cannot access *.rtl
mv: cannot access *.tree
mv: cannot access *.loop
mv: cannot access *.dbr
mv: cannot access *.jump2
mv: cannot access *.sched
mv: cannot access *.cse2
mv: cannot access *.sched2
mv: cannot access *.stack

mv cp/*.o stage1/cp
mv: cannot access cp/*.o
*** Error code 2 (ignored)


	If anyone can point me in the right direction, I would greatly 
appreciate it .... BTW, please respond to the following email address:

	hobika@pixel.kodak.com

-Thanks, Tom