🚀 go-pugleaf

I am trying to install gcc on a SGI power challange

%uname -a
IRIX64 penne 6.0.1 12130107 IP21 mips

I have installed binutils-2.6 fine and then did the following
./configure --with-gnu-as --with-gnu-ld 
and then tried to make and got the following error
gmake LANGUAGES=c
Lots of stuff

./xgcc -B./  -DIN_GCC   -g -I./include    -DNO_MEM -DNO_LONG_DOUBLE_IO 
-O0 -I. -c ./enquire.c
cc1: warning: `-g' not supported by this configuration of GCC
./enquire.c: In function `cprop':
./enquire.c:1382: warning: comparison is always 0 due to limited range of 
data type
/usr/tmp/cca004VY.s: Assembler messages:
/usr/tmp/cca004VY.s:3: Error: Unknown pseudo-op:  `.section'
/usr/tmp/cca004VY.s:13: Error: Unknown pseudo-op:  `.section'
/usr/tmp/cca004VY.s:58: Warning: Instruction not supported on this processor
/usr/tmp/cca004VY.s:58: Internal error!
Assertion failure at targ-cpu.c line 1478.
Please report this bug.
gmake: *** [enquire.o] Error 1

I have not built gcc before and may have done something wrong but I have 
looked around and have not found anything.  If you need any info I would 
be glad to send it to you.  
Thanks for any help in advance
Matt

********************************************************************
matt@barkley.Berkeley.EDU

Matt Bettencourt
(Home) (510) 215-6841
(Office) (510) 642-0916	6112 Etcheverry Hall UCB Berkeley CA 

"You can't fight evil with a macaroni duck!"
-Arthur 
********************************************************************