Re: HP700 running HPUX

Article View: gnu.gdb.bug

Article #380

#380

From: Ronald Cole
Date: Sun, 16 Aug 1992 16:00

22 lines
1618 bytes

In article <DOUGG.92Aug13120200@kbsw3.kbsw1.uucp> dougg%kbsw3@kbsw1.UUCP (Doug Gerecht 806 1031) writes:
   In article <9208130252.aa15810@s.s.ms.uky.edu> randy@ms.UKy.EDU (Randy Appleton) writes:

      I'm trying to get gdb4.6 dated July 14th running on our HP 700 series
      workstations under hpux.  Is this a suported configuration?

      I have run "configure hppahpux" in the gdb-4.6 directory.  This for
      some reason did not configure the subdirectories, such as readline,
      mmalloc, etc.  So I manually ran the same configure on the subdirectories.

   Get the HP support via ftp from jaguar.cs.utah.edu, in
   dist/pa-gdb-4.6.tar.Z.

It should be noted that pa-gdb only supports pa-gcc.  That is to say that
you cannot use pa-gdb to debug programs compiled with the native compiler.
I found out the hard way, since this "fact" is not documented.

--
Ronald Cole           +----------------------+  internet: rjc@unify.com
Software Engineer II  | This space for rent. |  uucp:     uunet!unify!rjc
Unify Corporation     +----------------------+  voice:    +1 916 928 6238
          "THE BILL OF RIGHTS --- Void where prohibited by law"

Technical Details

Message-ID: <RJC.92Aug16120012@devo.unify.com>

Path: arc1-ca.pugleaf.net!sparky!uunet!cis.ohio-state.edu!devo.unify.COM!rjc

References: rjc@devo.unify.COM (Ronald Cole)

Show Full Headers

Complete Article Headers

Newsgroups: gnu.gdb.bug
Path: arc1-ca.pugleaf.net!sparky!uunet!cis.ohio-state.edu!devo.unify.COM!rjc
From: rjc@devo.unify.COM (Ronald Cole)
Subject: Re: HP700 running HPUX
Message-ID: <RJC.92Aug16120012@devo.unify.com>
Sender: gnulists@ai.mit.edu
Organization: Unify Corporation, Sacramento, California
References: rjc@devo.unify.COM (Ronald Cole)
Distribution: gnu
Date: Sun, 16 Aug 1992 16:00:12 GMT
Approved: bug-gdb@prep.ai.mit.edu
Lines: 23

Reply to Parent Message