CAD for IBM PC

Thread View: net.micro.pc

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by James P. Kiely Tue, 23 Sep 1986 19:34

#8008

Author: James P. Kiely
Date: Tue, 23 Sep 1986 19:34

21 lines
1368 bytes

I am planning to buy an IBM PC/AT for the expressed purpose
of CAD.  I am planning to use it immediately for schematic
capture and Printed Circuit Board design.  In the future, I
will also be doing semi-custom IC work (ASIC's) and circuit
simulation.

- What configuration machine should I buy?

- Where can I find an authoritative review of CAD software for the PC?

- Does anyone on the net have any suggestions for packages that I should
  either look into or avoid?

As usual, I will summarize the results of these queries to the net.
Thanks.
-- 
 
NAME:     James P. Kiely                USPS:   Lown Cardiovascular Laboratory
USENET:   ...!harvard!lownlab!kiely             Harvard School of Public Health
PHONE:    +1 617 732 1307                       665 Huntington Avenue
                                                Boston, MA 02115-9915

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads