Pulling those RAMs

Thread View: ont.micro.mac

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by info-mac Wed, 11 Jul 1984 08:10

#475

Author: info-mac
Date: Wed, 11 Jul 1984 08:10

11 lines
947 bytes

Date: Mon, 09 Jul 84 17:17 PST
From: uw-beaver!Dennis.Griesser@HIS-LA-CP6.ARPA
To: INFO-MAC@SUMEX-AIM
Subject: Pulling those RAMs

Edward.Tecot is quite correct.  When dealing with an expensive (and
presumably delicate) printed circuit board, you don't want to take
any chances.  Cut the chips out and carefully clean up afterwards.

If you care about the old chips, do the job neatly and you can
probably solder them on to DIP headers.

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads