🚀 go-pugleaf

In article <C0nyI5.MG2.2@cs.cmu.edu> rwc@ius4.ius.cs.cmu.edu (Randy Casciola) writes:
>
>I just bought one of those cheap anti-static mats at a computer
>......
>Well, when I held
>the leads against the mat and pressed firmly at a distance of 
>about 1 cm, the resistance was greater than the highest range on
>the DVM ( >20M ohms).  

We have a special tester to determine the conductivity of the static
mats around our plant. What you need to remember is that the mats are
"static dissipative", not conductive. Dissipative is defined as being
between 10E5 and 10E11 ohms per square inch. Most of the mats around
here are about 10E7, or 100 Mohms per sq inch. The tester has two 
conductive bars which are placed on the mat. 100 volts is applied to
one and the current between them is measured to determine resistance.
Remember, the charge your trying to get rid of is thousands of volts,
not tens of volts.

>And the resistance from one end of the
>ground cord to the other was about 1M ohm.  I assume they have
>a 1M ohm resistor in series somewhere.

Yes, there is usually a 1 meg resistor in the ground lead. That's so
there's no high-current ground path, which could be a real 'pain' if
you are working a high voltages and get across the wrong wire.

>I measured the 
>resistance of another more expensive mat (the type designed to
>be placed on the floor for you to walk on) and at 25 cm of 
>distance between the leads I measured about 20k ohms.

Floor mats are supposed to be at ground potential so they are
CONDUCTIVE, not dissipative. They are usually hard grounded,
without the 1 Mohm current limiting resistor. They should be
used with 'shoe straps'. These basically ground your ankel to 
the floor. The strap has the 1 Mohm resistor and has to be tested
often. Around here, you are supposed to test you straps every
time you enter the production area.



John

"ESD dosen't really exist. It was invented by the 3M marketing
 department as a way to move conductive plastics." :-)


-- 
+--------------------------------------------------------------------------+
| John R. Schuch  -  Motorola Computer Group  -  Manufacturing Engineering |
| N7XVS - schuch@phx.mcd.mot.com - (602) 438-3008 - CompuServe: 70733.3330 |
+--------------------------------------------------------------------------+