🚀 go-pugleaf

I need a source for the following:

	     back
	------------------
	|                |
	|                |
	|                |
	|                |
	|                |
	|                |
	|                |
	|=              =|
	     front
This is the top view. It's simple sheet metal, and the back bolts to
the wall. The "=" is 19" rack spacing, with EIA drilling.

In other words, this is piece-of-rack, that you bolt to the wall. No
top. No bottom. One bent-up piece of sheetmetal. It will come in a few
depths -- say 5" 11", etc. and several heights - 3", 5", etc.

Bud, at least wants to sell me one that has a hinge at the left "|="
joint. Don't need it, nor want to pay for it, plus theirs is only 5"
deep.

Does anyone sell anything this easy, or do I need to get a sheet
metal shop busy? (sounds stupid, but hey...)
-- 
A host is a host from coast to coast.................wb8foz@nrk.com
& no one will talk to a host that's close...........(v)301 56 LINUX
Unless the host (that isn't close)....kibo# 777............pob 1433
is busy, hung or dead..............vr....................20915-1433