🚀 go-pugleaf

In article <4367@sugar.hackercorp.com>, gregw@sugar.hackercorp.com (Greg White) writes:
> Anyone have any experience or data using the Radio Shack BarCode
> Reader on computers other than the Model 100 it was designed for?
> I would especially like to get a pinout diagram of the connecter.

	The following is a *guess*, so use the information with caution.

	I believe that the Model 100 used an "industry standard" 9-pin
subminiature D-connector interface for a bar code wand.  Bar code wands
fall into three categories: (1) analog output; (2) digital output (NOT
decoded); and (3) "smart" with a serial decoded output.

	The analog output variety generally use a 5-pin DIN connector, and
the digital output variety generally use a 9-pin D-connector with the
following pinout and functions (as viewed by the wand):

	Pin 2	Wand output; a TTL line sunk to ground, usually with
		an open-collector transistor.

	Pin 7	Ground

	Pin 9	Supply voltage, usually +5 volts

	All other pins are unused.

	For further information, consult an H-P Optoelectronics Catalog
and look at the HEDS-3000 digital bar code wand.

	Bear in mind that I *believe* that the Model 100 uses the above
digital wand interface, but that I am not 100% certain. 

<> Larry Lippman @ Recognition Research Corp. - Uniquex Corp. - Viatran Corp.
<> UUCP  {allegra|boulder|decvax|rutgers|watmath}!sunybcs!kitty!larry
<> TEL 716/688-1231 | 716/773-1700  {hplabs|utzoo|uunet}!/      \uniquex!larry
<> FAX 716/741-9635 | 716/773-2488      "Have you hugged your cat today?"