🚀 go-pugleaf

Does anyone out there know how to do this?  This is a Toshiba 
multi-line (6 line) Key system.  Each tel. set has an electronic
ringer which sounds through a speaker.  The obvious solution is to
clip the leads to the speaker. But, if I do that, I lose the 
speakerphone etc.  There are two volume controls on the phone, however,
the volume control for the ringer also controls the volume of the
speaker when it is used for the paging intercom.  I looked at the
board and did not see any DIP switches or labled jumpers for turning
off the ringer.

If someone out there has serviced this type of system I would appreciate
some advice.  Thanks.

Please E-mail to shawn@panix.com