Has anyone programmed DT-2853 f.grab?

Thread View: sci.image.processing

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by ritley Tue, 08 Sep 1992 12:47

#436

Author: ritley
Date: Tue, 08 Sep 1992 12:47

16 lines
964 bytes


We have recently acquired a Data Translation DT-2853 "low-cost"
frame grabber.

Does anyone have any experience programming this board?

I am new to programming personal computers in the C language, and
I am experiencing some difficulty in reading/writing the registers
which control this board.

Unfortunately the company (Data Translation) insists that most people
abandon the manual which accompanies this product, and instead
purchase additional software, which I am reluctant to do.

Many thanks!

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads