🚀 go-pugleaf

Hi all,

When doing a second MAD run with an additionally found heavy atom
(mad_phase2.inp), I get the following error:

 XRAY>     set message=normal echo=on end 
 XRAY>   else 
 XRAY>     set message=off echo=off end 

 %DO-ERR: unrecognized statement or variable/type mismatch:
    do (mad=amplitude( ))
                       ^
 %XDOTYPE-ERR: Variable/type mismatch:
    do (mad=amplitude( )) 
                        ^
 %XDOTYPE-ERR: Variable/type mismatch:
    evaluate 
    ^^^^^^^^
 %DO-ERR: Expression incomplete:
    evaluate 
    ^^^^^^^^
 %SHOW error encountered: There were errors in DO expression.
   (CNS is in mode: SET ABORT=NORMal END)
 *****************************************************
 ABORT mode will terminate program execution. 
 *****************************************************
 Program will stop immediately.

I use CNS1.0 on SuSe 6.4. Any ideas?

Thanks a lot and best regards

Bernhard
*****************************
Dr. Bernhard Spingler
University of Zuerich
Inorganic Chemical Institute
Winterthurerstr. 190
CH 8057 Zuerich
Switzerland