MAD error in CNS

Thread View: sci.techniques.xtallography

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by Bernhard Spingler Fri, 25 Oct 2002 11:19

#25

Author: Bernhard Spingler
Date: Fri, 25 Oct 2002 11:19

40 lines
2112 bytes

Hi all,

When doing a second MAD run with an additionally found heavy atom
(mad_phase2.inp), I get the following error:

 XRAY>     set message=normal echo=on end 
 XRAY>   else 
 XRAY>     set message=off echo=off end 

 %DO-ERR: unrecognized statement or variable/type mismatch:
    do (mad=amplitude( ))
                       ^
 %XDOTYPE-ERR: Variable/type mismatch:
    do (mad=amplitude( )) 
                        ^
 %XDOTYPE-ERR: Variable/type mismatch:
    evaluate 
    ^^^^^^^^
 %DO-ERR: Expression incomplete:
    evaluate 
    ^^^^^^^^
 %SHOW error encountered: There were errors in DO expression.
   (CNS is in mode: SET ABORT=NORMal END)
 *****************************************************
 ABORT mode will terminate program execution. 
 *****************************************************
 Program will stop immediately.

I use CNS1.0 on SuSe 6.4. Any ideas?

Thanks a lot and best regards

Bernhard
*****************************
Dr. Bernhard Spingler
University of Zuerich
Inorganic Chemical Institute
Winterthurerstr. 190
CH 8057 Zuerich
Switzerland

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads