🚀 go-pugleaf

In article <844724422.25018.0@ibis.demon.co.uk>, Gareth Jones
<gareth@ibis.demon.co.uk> writes:

>
>I need to get inside an HP660C - I've got nasty lines on my print outs
>which look like they are caused by dirt somewhere wiping across the
>page after the ink has been squirted on. I've cleaned everything
>visible without effect.
>
>the machine seems to be held together with some kind of magic. Does
>anyone know how to get in???

I suspect you might need even greater magic to put it back together if
you do :-(

You are probably suffering from a build up uf fluff on the underside of
the carriage. Try this:

        Power ON the printer and raise the lid.

        Remove the cartridges.

        Lift off the paper tray and remove the paper.

        Press down on the black plastic bar that runs across in front of
        the paper feed wheels.

        You should now have sufficient access to clean the underside of
        the carriage with a moist lint free cloth or foam tipped wipe.

        You might also need to wipe the rubber seals in the docking
        station at the right hand side of the printer where the heads
        are normally parked.

Good luck.

-- 
Mike Clarke