🚀 go-pugleaf

I have a v.90 modem and dun always reports 26,400.Sysmon reports 26,400 on
large transfers,it starts out initially at 3.7 to 4.0 but levels out at
26.4.I would accept this if 26.4 varied on dun at different log in times but
it does not.

I have tried many .inf files and extra inits but the above is the best I
have been able to achieve.

I am 1500 cable feet from a digital loop concentrator remote.The remote is
connected by 15 miles of fiber to the local terminal co-located with a
DMS-10 central office switch.The remote and local terminal of the DLC each
have D/A conversion and the switch converts analog to digital on the line
equipment card.This results in 3 D/A conversions in my service loop,not
counting modem,so I suspect this is the problem.But,why always 26.4?It could
and should be slower from time to time.

Not much help but hope info helps.
Julio Alano wrote in message ...
>Is anyone else suffering from this or is it just me?
>Any comments are welcome.
>I am in Washington State area. I connecting using an internal 56k pci
modem.
>It will only connect at 26.4k (reported by DUN) althought the download
>speeds suggest I am getting closer to or just over 28.8k.
>I have tried  3 different ISPs and a number of locations/lines. My modem
>supports both K56Flex and V.90 and I have tried ISPs offering all three
main
>protocols.
>Does anyone have experience of this or any suggestions of fixes.
>
>Cheers, Julio
>
>
>