🚀 go-pugleaf

In article <4q443f$ijt@al.imforei.apana.org.au>, 
pjchilds@al.imforei.apana.org.au says...
>
>Adam Frey (adam@eden.apana.org.au) wrote:
>: In <4q3l1u$5od@chuckie.apana.org.au> braddock@labrador.apana.org.au (Reg 
Bra
>ddock) writes:
>
>: >I have an incredibly irritating problem - the printing on each
>: >successive page is 10mm further down the page than the last page.  The
>: >result is that, after only a few pages, the output spews across
>: >sheets.
>
>[cut]
>
>: I suffered with this problem for about a year and a half. It was present
>: under OS/2, Linux and FreeBSD. The simple answer is that neither the 10e
>: nor the 200 modes in ghostscript are properly compatible with the 330.
>
>: If there is a solution other than using a different printer, I never found
>: it.
>
> Check the config files for ghostscript looking for the a4 paper size
> definition.... when you find it you'll see it describes the size
> in some wierd measurement... now check exactly what a a4 page *should*
> be and what your printer is printing... and scale the number and
> create a new page size definition.
>
> Should work.

Hi Peter,


It hasn't worked so far :(  I think my next printer purchase will be 
postscript to save pissing around.

Reg.

-- 
---------------------------------------+----------------------
Reg Braddock                           |Pregnant?  Single?
Phone:  +61 018 899 474                |Need Support?
Email:  braddock@labrador.apana.org.au |Our mobile scaffolding
WWW:    http://labrador.apana.org.au/  |service can really
                                       |take the load off.
---------------------------------------+----------------------